Metric

• Working fluid: Water
• Working temperature up to max.: 90°C
• Models: Single zone (M) Double zone (D)
• Configuration: Direct cooling, heating with electric heaters
• Applications: Injection moulding, blow moulding, extrusion.

----------------------------------------------------------------------------

ADVANTAGES:

• High flow rate  (ΔT = 2°C)
• High Cooling capacity
• High product precision
• Minimum running costs
• Simple and safe use 
• Maximum repeatability  and process efficiency

SPECIFICATIONS

CONTROL PANEL
Interface is easy and simple to use.
The Display shows the temperature level  in big types and there is a wide alphanumeric operating screen.

MICROPROCESSOR
Monitoring of several parameters (operating pressure and temperature). Temperature control with precision of  ±0,3°C,  The temperature variation is  tune-up following a proportional-integral logic.
Permanent digital read-out of the process water temperature and pressure. Messages are shown in the selected language among the five available.

CONTROL AND ELECTRICAL CIRCUIT
Electrical panel EN 60204/1, IP 55 certified with shut-off switch .
Procedures are completely automatic for loading and unloading mould circuit.
Main alarms: no flow, high and low pressure in the circuit, short circuit or disconnection of any probe, temperature warning for prolonged deviation from the set-point. Acoustic alarm, prearranged optic alarm, which can be also remote-installed.

INTERFACEABILITY
Serial protocol for production machines of the most famous trademarks. Signal retransmission and remote-set analogue signals. 

HYDRAULIC CIRCUIT
High-performance stainless steel pumps, with special seal and tropicalized motor (up to +60°C).
Pressure adjustment by-pass device. Manual or automatic loading. A kit for the automatic draining of the unit circuit is available.
The internal hydraulic circuit consists of 100% of stainless materials so to ensure maximum life.
Safety valve.
Temperature control system consisting of a modulating adjusting valve: precision and energy saving.

FRAME
Made of steel painted with epoxy powder, removable panels, installation on rotating wheels.

AVAILABLE RANGE
Heating power is  6 and 12kW by means of Incoloy® low surface load heating elements.